Add Engine Oil - Craftsman 580.754902 Instrucciones De Uso

5. Place billboard (A) over holes (B) on handle
(viewing from front of unit). Push the small tree
clips (C) into the holes until they sit flat against the
accessory tray.
C
6. Insert spray gun holder wireform (D) through hole
on handle and attach a plastic knob (E). Tighten by
hand.
E
Project Pro® Perfect Mix™ Siphon
1. Attach the tube end of the blue PerfectMix siphon
(F) to the barbed tube fitting (G) on the pump.
F
2. Place Perfect Mix bottle (H) (not included) in
spaces of accessory tray.
F
H
3. Remove cap from bottle and insert Perfect Mix
siphon (F). Screw siphon unit to top of bottle.

Add Engine Oil

1. Place pressure washer on a flat, level surface.
2. Clean area around oil fill and remove yellow oil fill
3. Hold neck of supplied oil pouch and remove cap.
A
4. Slowly pour contents of oil pouch into oil fill
B
NOTICE Pause to permit oil to settle. Wipe dipstick
clean each time oil level is checked. DO NOT overfill.
NOTICE Improper treatment of pressure washer
D
could damage it and shorten its life.
• DO NOT attempt to crank or start the engine before it has
5. Replace oil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
G
NOTICE Use of unapproved fuels could damage
pressure washer and voids warranty.
• DO NOT use unapproved gasoline such as E15 and E85.
• DO NOT mix oil in gasoline or modify engine to run on
8
cap/dipstick.
opening. Checking oil level frequently, fill to FULL
mark (top hole) on dipstick.
been properly serviced with the recommended oil. This
could result in an engine failure.
• Clean, fresh, unleaded gasoline.
• A minimum of 87 octane/87 AKI (91 RON). For
high altitude use, see High Altitude.
• Gasoline with up to 10% ethanol (gasohol) is
acceptable.
alternate fuels.
WARNING Fuel and its vapors are extremely
flammable and explosive which could
cause burns, fire or explosion
resulting in death or serious injury.
WHEN ADDING FUEL
• Turn pressure washer engine OFF and let it cool at least
2 minutes before removing fuel cap. Loosen cap slowly to
relieve pressure in tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights,
heat, and other ignition sources.
• Check fuel lines, tank, cap and fittings frequently for
cracks or leaks. Replace if necessary.
• DO NOT light a cigarette or smoke.
Full
Add