Connecting The Headphones; Setting The Basic Functions; Switching On The Device For The First Time; Standby Menu - Sonoro sonoroRadio Instrucciones De Manejo

2. Insert the supplied button cell (CR2032, 3 V)
with the label (+) side up.
3. Close the battery compartment.
7.6

Connecting the headphones

The headphones can be connected to the device with
a 3.5 mm stereo jack (not included in the scope of
delivery).
L WARNING!
Risk of injury from improper headphone use!
Improper use of headphones can cause severe
accidents and damage to health.
– Do not set the volume too high when using the
headphones.
1. Turn the click wheel to the left to set the volume
to minimum.
2. Insert the headset jack into the headset port at
the back of the device.
3. Slowly turn the click wheel to the right to
increase the volume.

8 Setting the basic functions

The individual menus let you select the functions and
settings of the device.
8.1 Switching on the device for the first
time
After you have switched the device on for the first
time, the LC display shows the clock display and the
message [Tune to FM RDS station to set time & date].
i
In FM/DAB mode, time and date are set automati‐
cally as long as this has not been disabled.
8.2

Standby menu

You can adjust the following settings in the Standby
menu:
n Manually set the time.
n Manually set the date.
n Switch the date on the display on/off.
The procedure for setting the individual functions is
the same.
84
Setting the time manually
Fig. 10: Setting the time
1. Press the [MENU] button on the device or the
remote control in Standby mode.
ð The display shows the [Set Time] menu
(Fig. 10).
2. Press the click wheel to set the hours.
ð The hour display flashes.
3. Turn the click wheel to set the hours.
4. Press the click wheel to confirm the setting.
ð The minute display flashes.
5. Turn the click wheel to set the minutes.
6. Press the control knob to confirm the setting.
ð The time is set.
i
Use the [Next ] or [Previous] button to
switch between the hours and minutes
display.
i
After 10 seconds of inactivity, the device automat‐
ically goes into Standby mode without saving the
settings.
Setting the date manually
Fig. 11: Setting the date
1. Press the [MENU] button on the device or the
remote control in Standby mode.
ð The display shows the [Set Time] menu
(Fig. 10).
2. Turn the click wheel until the display shows
[Set Date].