TOHATSU MFS 5C LPG Manual Del Propietário página 53

2. Turn the steering on the outboard
motor left.
3. Put a oil drain pan under the oil drain
screw.
4. Remove the oil drain screw and com-
pletely drain oil from the engine.
1. Drain hole
5. Tighten the oil drain screw with apply-
ing oil on the sealing surface of screw.
(Use new oil drain washer)
Oil drain screw specified torque
18Nm (13 ft lb, 1.8 kgf
-
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
6. Reset the engine in a vertical posi-
tion.
7. Repeat 3 to 7 procedures two or
three times to drain the oil com-
pletely.
8. Remove the top cowl and the oil filler
cap.
1
ENOF01513-0
m)
-
INSPECTION AND MAINTENANCE
9. Fill the engine through filler port with
recommended oil (see chart below)
to the middle of dipstick mark.
10. Tighten the oil filler cap.
1
1. Oil filler cap (Dipstick)
1
2
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 12)
10W−40
10W−30
-30 -20 -10 0 10
-22 -4 14 32 50
51
ENOF00446-0
ENOF00447-0
20 30 40 ˚C
68 86 96 ˚F
ENOF00208-0
10