Setting The Sensor - Velleman HAM222 Manual Del Usuario

5. Installation
Choose the installation spot considering the following:





Setting the Sensor

Prior to installing the batteries, move the switch to set the sensor
sensibility:
V. 04 – 26/02/2019
Install the alarm module within the range of the remote
control. Refer to the picture below.
The powerful and accurate microwave sensor will detect
movement even behind non-metal PVC or wooden walls or
doors. It is not recommended to install the alarm module
behind or near metal panels or near interfering signals.
Make sure the installation spot is flat, dust-free, protected
from rain and other weather elements, and not prone to
vibrations.
Install the alarm module in a spot where the device cannot
be tipped over.
Low: 2 m (front) – 5 m (back)
Mid: 4 m (front) – 8 m (back)
Hi: 6 m (front) – 12 m (back)
HAM222
4 ©Velleman nv