Multiplex POWER PEAK QUAD EQ-BID 230V Instrucciones De Uso página 38

Power Peak® Quad EQ-BID 230 V
Cell count
1
2
3
4
5
6
ENTERING THE BATTERY CAPACITY
ted in steps of 100 mAh (PB, 500 mAh). The battery capacity setting for lithium battery
packs mainly serves as the basis for the 1C charge, i.e. the charging current is auto-
Battery type
NiCd
NiMH
LiPo
LiIo
LiFe
Pb (lead)
SETTING THE CHARGING CURRENT
Press the 'INC/ DEC ' button to leaf through the screen display until the arrow is next to
to 5A can be selected in steps of 0.1 A. The maximum charging current is dependent on
the number of cells or the battery voltage and the maximum charging capacity (max. 2C
for lithium batteries). The processor in the battery charger limits the maximum charging
current if the maximum charging capacity is exceeded.
Operating Instructions
Alternatively, for lead-acid batteries you can select
a battery voltage in increments of 2 V per cell using
the 'INC' or 'DEC' button. Press the 'ENTER' button
again to confirm your selection.
Battery voltage
2 Volt
4 Volt
6 Volt
8 Volt
10 Volt
12 Volt
Press the 'INC/ DEC ' button to leaf through the
screen display until the arrow is next to Battery
Capacity. Press the 'ENTER' button and the '+ / -'
symbol flashes. The battery capacity can be selec-
Battery capacity
100 - 9900 mAh
100 - 9900 mAh
100 - 9900 mAh
100 - 9900 mAh
100 - 9900 mAh
0,50 Ah - 20,00 Ah
End. Press the 'ENTER' button and the '+ / -' sym-
bol flashes. The charging current can be selected
in steps of 0.1 A. Press the 'ENTER' button again
to confirm your selection. The charging current up
14
38
The following voltages are available to
use for lithium batteries:
matically set to the corresponding 1C
charge of the battery. It additionally
serves as a battery safety function.
Press the 'ENTER' button again to
confirm your selection. The range of
capacities shown in the table here are
available and depend upon the type of
battery:
# 30 8196