Installation Instructions; Operating Instructions - Clarke American Sanders CAV super 30 Manual Del Operador

ENGLISH
EN

INSTALLATION INSTRUCTIONS

Uncrating & Installation
1. Carefully remove all of the packing materials and check
the parts against the Packing List.
2. Your machine was test-run and shipped with all fluids at
the proper levels. Check them now and top off as
required.
3. Using a forklift, or other means, place the machine in a
trailer or truck (for information on recommended trailer
specifications and layout see page 10). The trailer or
truck must have two 48" side doors, one on each side,
for proper engine ventilation (consult the factory for the
proper location).
4. Position the unit so that the vacuum and engine
exhaust out of the open doors. Inlet valves should be
accessible at the side door.
5. Drill out the holes to the proper size and bolt the unit in
place, fastening it to the metal joists in the trailer floor
(refer to the mounting footprint on page 15).
WARNING: Machine must not be operated,
transported or stored without being securely
fastened to a stable base.
DANGER:
1.) This machine MUST be grounded.
2.) The side doors MUST be open during
operation.
Failure to do so may lead to an accumulation of
static electric charge and vented fuel fumes that
may ignite in the trailer body.
6. Fill the gas tank. Your new machine is now ready for
operation.

OPERATING INSTRUCTIONS

Start-UP
WARNING: At all times keep your hands, clothing,
etc., away from the inlet and discharge of the
machine.
1. Attach the hose(s) to the air inlet (see figure 1) of the
machine, using the hose connectors provided.
NOTE: Two 2" air inlets allow the operators flexibility
with how and where they want to run hoses into the job
site. Two operators can work completely independent
of each other.
2. Attach additional hose lengths to the hose(s) with hose
connectors.
3. Attach hose(s) to floor sanding machine as required.
-6- Clarke ® American Sanders
Figure 1
Operator's Manual (EN) - C.A.V. Super 30