Service & Maintenance - Belle Group Minitile 180 Manual Del Operador

GB
Before performing any maintenance operation, ensure the machine is disconnected from the power
CAUTION
supply.
MINITILE & MAGIKTILE ONLY!!
DIAMOND BLADE DISASSEMBLY
Remove the blade guard.
Use the 4mm Allen Key to hold the motor shaft. Unscrew the blade fl ange block nut with
the 19mm spanner.
After removing the blade, clean the blade fl ange thoroughly and check for wear.
Lubricate surfaces with fi ne oil, then fi t new blade.
MAXITILE ONLY!!
After dismantling the blade, clean the blade
fl anges carefully and check them for wear.
Grease any surface with fi ne oil and go on
with the assembly of a new blade.
Check for correct direction of rotation as
clearly indicated on the blade.
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with a register
for the vertical play adjustment. If any
excessive play of the motor carriage should
take place, act as follows:
1) Loosen the register fi xing nut with a
10mm spanner;
2) Screw down the dowel with a 4 mm Allen
Key until the play is eliminated;
3) Lock the register again with the fi xing nut.
CLEANING
It is extremely easy to clean the MAXITILE machine by loosening the side knobs and
dismantling the working table.
Through the side drain remove any residue (See picture 7d).
When necessary clean the sprayer as shown in pictures 7e and 7f
Maintenance
.
10
7b
7d
7a
7c
7e
7f