Sensotherm TSC5 Instrucciones De Servicio página 12

Operating manual
TSC5
0-10Volt mode
The step control of the circuit board can take place via an external 0-10Volt-signal. No
control unit (operating device) may be connected in the 0-10Volt-operating. The heat-
ing output is not used in this mode of operation and/or is not activated
If the LED display (26) is on then the thermal contact of the motor is re-
leased. If the LED display flashes then the signal and/or communication
between the control unit (operating device) and circuit board (master) is
disturbed. A thermal contact motor problem has priority over a signal
ATTENTION
connection problem.
12
.