Basic Operation - Teac LPR550USB Manual Del Usuario

H Skip/Search (.m/,/), TUNING (
In CD mode, use these buttons to skip tracks .
Hold down these buttons to search for a part of a track .
In FM/AM mode, use these buttons to tune in a station .
I RECORD
Use this button to enter record pause mode .
J CD operation buttons
PLAY/PAUSE (y/J)
Use this button to start or pause playback or recording .
STOP (H)
Use this button to stop playback or recording .
K Speakers (stereo)
L OPEN/CLOSE (L)
Use this button to open or close the disc tray .
M
Remote Sensor
When operating the remote control unit, point it toward the
remote sensor .
N
VOLUME
Turn this knob to adjust the volume .
O
Disc Tray
P REC LEVEL
In record pause mode, use this knob to adjust the recording level .
Q PHONES
When you use headphones, first reduce the volume level to
minimum . Then, insert the plug from your headphones into the
PHONES jack, and turn the volume up gradually by turning the
VOLUME knob .
< Do not turn the unit on or off, or insert or pull out the
headphones jack while wearing the headphones .
(Excessive sounds may occur from the headphones . )
< The sound from speakers will be cut off while the headphones
are plugged in .
The following buttons are provided only on
the remote control unit.
R PROGRAM
In CD mode, use this button to program tracks .
S CLEAR
In CD mode, use this button to clear the program you set .
T REPEAT
In CD mode, use this button to select a repeat mode setting .
U DISPLAY
In CD mode, use this button to change the display .
V SHUFFLE
In CD mode, use this button for shuffle playback .
Note:
To simplify explanations, instructions in this document refer
to only the names of buttons and controls on the front panel,
making no mention of the use of remote control unit .
)
1 Press the POWER button to turn the unit on.
2 Select a source by pressing the corresponding button.
< To listen to an external source connected to AUX jacks, select
AUX by pressing the PHONO/TAPE/AUX button once or twice .
3
Play the source, and adjust the volume by turning the
VOLUME knob.

Basic Operation

13