Tripp-Lite DWM1323SP Manual Del Propietário página 6

3b. Mount on Solid Brick and Concrete Block
Concrete Anchor
• When installing wall mounts on cinder block, verify the actual concrete thickness
is at least 1-3/8" (35mm) for using the concrete anchors. Do not drill into mortar
joints! Be sure to mount in a solid part of the block, generally 1" (25mm) minimum
from the side of the block. It is suggested an electric drill on a slow setting be used
to drill the hole instead of a hammer drill to avoid breaking out the back of the hole
when entering a void or cavity.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
13-08-142-933298.indb 6
Anchor Bolt
WARNING
6
1
Find and mark the
exact location of
mounting holes
2
Drill pilot holes
Screw the wall
plate onto the
wall
8/13/2013 12:56:25 PM