Publicidad
Idiomas disponibles
Idiomas disponibles
Pairing the remote control
Important: By default the included remote control is paired with your receiver. When the remote control does not
respond, please follow this pairing procedure step by step.
1) Put the battery in the remote control.
2) Make sure the fan is powered by electricity.
3) During the first 30 seconds, the pairing channel remains open, within this interval press the ON / OFF button on your
remote control for 5 seconds.
4) A beep emitted by the remote control and the fan indicates that the two elements are paired.
Note 1: A beep sound will be heard when a function is transmitted and received by the receiver.
Note 2: The engine does not react instantly, be patient.
Note 3: The Memory function is active, it records the last status before disconnection.
Note 4: Remove the battery from the remote control if you are not using your fan.
Note 5: To change the direction of rotation, you must turn the fan off.
Note 6: Only one remote control can be paired with this fan.
Note 7: When you turn off the switch and turn it back on, the light turns on automatically.
Balancing the fan
After installation, in some cases, you may hear a vibration from your fan. The higher the speed, the louder the sound will be.
This is due to the fact that your fan is unbalanced, there are several factors that can unbalance a ceiling fan, in most cases an
inconsistency on the blades is the root of the problem.
1) Measure the distance between each blade, and check that the space between the blades is the same. If this is not the case,
unscrew the correspondant blade and put it at the right distance.
2) Check the distance between the end of the blades and your ceiling, if you notice a difference in distance between the ceiling and
the blade, disassemble the blade, check that you have all the elements of the type washers.
3) Length of the blades. Check that all the blades are fixed in the same way with the same distance between the motor and the
end of the blades.
Finally, a balancing kit is provided in your fan, it is possible that a blade is lighter than 0.5 or 1 Gr than the others, which causes a
vibration.
To detect the blade that would be different, use the clip provided for this purpose. Attach the clamp to a blade and turn on the fan,
see if it improves balancing
Troubleshooting
Problems
The fan does not start
The fan vibrates
The fan makes noise
_ _
_ _
__
Possible reason
Solution
a. Circuit breaker
out of position.
b. The electrical
connections of
the fan moved
c. The battery of the
remote control is
at HS.
d. The fan is not
paired
a. The blades are
not horizontal to
the ceiling
b. Blades are
missing
a. There are
missing screws
b.
The fan is poorly
fixed to the
ceiling
a. Check your circuit breaker.
b. Check the connections of
your fan.
c. Replace the battery of the
remote control.
d. Pair your fan.
a. Review the balancing
sequence of the blades.
b. Tighten all the screws.
a. Tighten all the screws.
b. Tighten the screws of the
fixing plate.
______
____
__ ______
__
________
Publicidad
