Electrical Connection; Cleaning And Maintenance - Cata PROFESSIONAL 750 Instrucciones De Uso

It can be disconnected by making the plug
accessible or by incorporating a switch
in the fixed wiring that meets electrical
installation standards."
The manufacturer declares that this product
meets all the essential requirements for
low voltage electrical material set out in
European directive 2006/95/EEC of 12
December 2006 and for electromagnetic
compatibility as required by European
directive 2004/108/EEC of 15 December
2004.
The manufacturer declines all responsibility
for personal injury or damage to animals or
objects caused by inappropriate use of
the appliance according to the warnings
for installation, use and maintenance
described in this instruction manual.
After finishing the installation these
instructions should be given to the owner/
user of the appliance.
INSTALLATION:
Before starting the installation, check that the propeller
is not deformed or damaged, that it can turn freely, and
that no foreign body is lodged inside the outer casing.
The appliance shall be installed according to the
attached graphic documentation.
Such appliances must be set inside the kitchen
chimney, at a minimum distance of 50 mm. to the side
panels, as shown in fig. 1.
For its installation, make two holes of 6 mm. diametre,
being 300 mm. distant.
Next, insert the plastic plug and screws hooks supplied
with the appliance and hand it from its rear side.
Following, mark in the wall the exact point where the
plastic plug should be placed to fix the extractor (hole
situated at the lower part of the cover).
Make sure that there is no obstacle blocking the flow
of air.
The appliance must be placed in such a way, that the
supply plug is accessible.
The appliance must be installed at a minimum distance
of 65cm from the stovetop.
If the installation instructions for the cooker indicate a
greater distance, this should be observed.

ELECTRICAL CONNECTION:

Make sure that the voltage (V) and frequency (Hz) of
the power supply correspond to the values indicated
on the nameplate.
The appliance must be permanently connected to fixed
installation.
(Cable rigid or stiff-tipped 3 wires, with a minimum
cross-section of 1 mm2 and maximum of 1.5 mm2).
APPLIANCE CLASS I: It must be connected to an
efficient ground connection.
If the appliance is connected with a plug, this must
be accessible.
In the event that this appliance is not used, it is
recommended that you disconnect it from the mains
electricity supply.
To finish the installation, verify that all the connections
have been done correctly and make sure that the
cables are placed correctly.
Make sure that the blades turn freely.
On appliance equipped with tungsten lamps, the lights
should only be used during operation of the motor.
They should not be left on permanently and used as
a light source.

CLEANING AND MAINTENANCE:

• Before cleaning make sure that the appliance is not
connected to the electric network and prevent it from
being reconnected by accident.
Firstly, take off the oil tray (1) and remove the filter
(2) by pulling out and downwards the handel in the
front side, to release it from its fixation to the extractor
cover (3).
Then, untight the screw (4) till loosing the piece (3).
Pulling up and towards, the piece will go out of the
fixation device (5), acceeding to the air ducting.
Following, loosen the nut counter clockwise to take off
the turbine (6). Turbine can be cleaned in the washing
machine.
The plastic cover must be cleaned with detergents
trying not to wet the motor.
For the assembly of this appliance, make the same
process but on the other way round, by FITTING THE
MARK OF THE TURBINE ( ∆ ) with the flat surface ot
the axle.
Keep the cleanning instructions on the packing for the
maintenance.