Door Reversibility (Glass Door Only) - ARTEVINO Oxygen Serie Manual De Uso

• Place the 2 caps in the 2 holes at the top of the cabinet,
ensuring that you do not push them all the way in.
• Slide the rear stop between the caps and the wall of the
cabinet, then push the 2 caps all the way in.
• Place your cabinet in the desired location.
The location that you choose for your cabinet must:
- be open to the outside and well ventilated (not in an
enclosed cupboard, for example),
- allow there to be a minimum space of 7 cm between the
wall and the back of the cabinet,
- not be close to any source of heat,
- not be too damp (utility room, laundry room, bathroom...),
- have a flat, stable floor,
- be supplied with standard accessible power (outlet that
complies with standards in force in your country, earthed with circuit breaker).
It is forbidden to use an extension cord or adaptor.
Fitting the handle
In order to correctly fit the handle on your wine cabinet's solid door, please follow these instructions.
Prepare the items required for assembly, supplied with your cabinet:
- The handle 1 ,
- 2 handle tubular supports ,
2
- 2 washers 3 ,
- 2 screws 4 ,
- 2 caps 5 .
You will also need a flathead screwdriver (not supplied)
Instructions :
1. Insert 1 washer on 1 screw.
2. Insert the handle tubular support then the screw in the hole provided on
the inside of the wine cabinet door.
3. Use the screwdriver to screw the screw into the handle post and gently
tighten.
4. Place the cap on the screw head.
5. Repeat this procedure for the other handle post.
Recommendation
To allow you to easily level your wine cabinet, it is fitted with 2 adjustable feet at the front.
Carry out final levelling of your cabinet (spirit level recommended).
WAIT 48 HOURS BEFORE PLUGGING IN YOUR APPLIANCE
When moving your cabinet, never tilt it more than 45°, and always on its side (on the opposite side of
the flexible lead).
7
1 5 4 3 2 1

Door reversibility (glass door only)

x3 x3 x3
A B C D
A F
Upper hinge
B G
Caps
C H
Caps
D J
Torx screw
E
Hex screw
This allows you to change the direction in which the door opens. Follow the instructions below (example
for changing a right-hand door into a left-hand door):
1
2
3
4
x4
E F G H J
x2
Door catch
Lower hinge
Door pin
Door pin cap
1
Unscrew the three screws using a "T25"
Torx wrench.
2
Remove the upper hinge.
3
Carefully remove the caps using a thin
blade.
4
Remove the cabinet door by opening it
slightly, then lifting it upwards.
5
Unscrew the door pin.
6
Carefully remove the cap using a thin
blade and assemble the pin in its place.
Reposition the cap on the opposite side
GB
8