Deprogramming A Transmitter (Only I-R Marki Ws/Wsrf); Functions In Reprogramming Mode (Only I-R Marki Ws/Wsrf, Only For Qualified Personnel) - Selve i-R Marki WS Manual De Instrucciones

Transmitter programming procedure

2.2) Deprogramming a transmitter (only i-R Marki WS/WSRF)

Press the PROG button on the sensor for 3 seconds (wait for confirmation: brief
upwards and downwards movement of the motor). The receiver remains in
programming mode for 1 minute. Briefly press (1 sec.) the PROG button of the
transmitter which is to be deprogrammed. The transmitter has now been
deprogrammed.
i-R Marki WS/WSRF
3 sec.
3.) Functions in reprogramming mode
(only i-R Marki WS/WSRF, only for qualified personnel)
In order to carry out the following settings, the receiver has to be put into repro-
gramming mode by disconnecting it from the mains supply.
Note: • A transmitter has to be correctly programmed before it can be put into
reprogramming mode.
• The receiver remains in service mode for 4 minutes.
• Only the put the receiver which is to be set into reprogramming mode.
• In order to take a receiver out of reprogramming mode (e. g. 3 re ceivers at
one fuse), the motor has to be actuated.
Fuse/Hirschmann plug
3 sec. 3 sec.
The receiver confirms the service mode by a brief up and down moving of the
motor.
Transmitter
➡
3 sec.
1 sec.
✓
27
GB