Guided Tour - Um1 Receiver And Frequency Conversion Chart - Samson UM1 Manual De Uso

1 2
A
UHF MICRO DIVERSITY RECEIVER
LOW
SAMSON
4
MIN
5
SQ LEVEL
+
6
7
6: Battery holder - Insert a standard 9-volt alkaline battery here, being sure to observe
the plus and minus polarity markings shown. We recommend the Duracell MN 1604 type
battery. Although rechargeable Ni-Cad batteries can be used, they do not supply adequate
current for more than four hours. WARNING: Do not insert the battery backwards; doing
so can cause severe damage to the UM1 and will void your warranty.
7: Plastic screwdriver - Specially designed for use in adjusting the UM1 Squelch Level
control (see #4 above). See the "Setting Up and Using the UM1 System" section on page
8 in this manual for more information.
8: Antennas (A and B) - The antenna mountings allow full rotation for optimum
placement. In normal operation, both antennas should be placed in a vertical position.
Both antennas can be folded inward for convenience when transporting the UM1. See the
"Setting Up and Using the UM1" section on page 8 in this manual for more information.
Guided Tour - UM1
3 1
B
800 MHz
MID HIGH PEAK
MAX
POWER ON
SAMSON
1: A/B Receiver LEDs - When signal is
being received, one of these will be lit
orange, showing you whether the (left) "A" or
(right) "B" receiver is currently being used.
The UM1 constantly scans its two antennas
and automatically selects whichever is receiv-
ing the strongest, clearest signal. This True
Diversity switching is completely inaudible,
but it effectively increases overall range while
virtually eliminating potential interference and
phase cancellation problems.
2: Meter - This set of three multicolor LEDs
acts as a meter, indicating either battery
power or the strength of the incoming RF
signal. This meter can also be disabled
altogether to conserve battery power. See
#15 on the next page for more information.
3: Peak LED - This LED lights red when
output signal from the UM1 is at the onset of
clipping (that is, when it is on the verge of
being distorted). If you see this light during
operation, move the microphone further away
or lower the output level of your instrument or
transmitter. For more information, see the
section entitled "Setting Up and Using the
UM1 System" on page 8 in this manual.
4: Power switch - Use this to turn the UM1
power on and off.
5: SQ (Squelch) Level control - This con-
trol determines the maximum range of the
UM1 before audio signal dropout. Although it
can be adjusted using the supplied plastic
screwdriver, it should normally be left at its
factory setting. See the "Setting Up and
Using the UM1 System" section on page 8 in
this manual for more information.
5