Bobbin winding (continued)
_] Push the bobbin to the right,
[]
With free end of the thread held in your hand,depress
the foot control Stop the machine when it has made a
few turns, and cut the thread close to the hole in the
bobbin,
[]
Depress the foot control again° When the bobbin is fully
wound, it stops automatically_
Return the bobbin winder
to its original position by moving the spindle to the left
and cut the thread
%_
r
%
,,,J
I===_
[_ Push the handwheel to the left to engage clutch,,
* The machine does not function until the clutch is
engaged,
NOTE:
Position of the bobbin winder stopper is adjustable for the
required amount of thread on bobbin (example 1/2 full or
full etc.), Use a screwdriver and loosen the screw one turn
or less to adjust the position of the bobbin winder stopper,,
Do not take out the screw all the way,
@
l
/J
2O