JB Systems DYNABARREL Manual De Instrucciones página 9

ENGLISH
Display Inversion
Display inversion: display is readable when the unit is mounted upside down.
 Press the [MENU] button until the display shows
 Press the [ENTER] button, the display starts blinking.
 Use the [DOWN & UP] buttons to select the display inversion or the normal display.
 Once the mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
Pan inversion
You can use this setting to invert the pan movement of the barrel
 Press the [MENU] button until the display shows
 Press the [ENTER] button.
 Use the [DOWN & UP] buttons to select the pan inversion
 Once the mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
Self-Test
Used to activate the internal "self-test" program that runs continuously.
Press the [MENU] button until the display shows
 Press the [ENTER] button to start the internal self-test program.
 The unit will run continuously in sequence each individual LED
 This self-test allow the user to check if all the LEDs are working perfectly.
If you want to go back to normal running mode: press the [MENU] button for about 2 seconds.
Fixture Hours
Used to show the number of working hours of the unit.
 Press the [MENU] button until
 Press the [ENTER] button to show the number of working hours in the display.
 Press the [MENU] button for about 2 seconds to return to running mode.
Software version:
Used to show the software version of the unit.
 Press the [MENU] button until
 Press the [ENTER] button to show the software version of the unit.
 Press the [MENU] button for about 2 seconds to return to running mode.
Reset
Used to reset the unit
 Press the [MENU] button until
 Press the [ENTER] button to reset the unit
OPERATING INSTRUCTIONS
A. Standalone 1unit:
 Just connect the projector to the mains.
 Select one of the automatic show modes
 Don't forget to set the Blackout mode to [NO Blackout] or nothing will happen.
 Don't forget to set the Sound mode to [ON] if you want the unit to be controlled by the beat of
the music.
 Refer to chapter HOW TO SETUP to learn how to make the previous settings.
Remark: You can connect a CA-8 remote controller to the unit if you want to have more control.
JB SYSTEMS
®
.
is shown on the display.
is shown on the display.
is shown on the display.
7/54
USER MANUAL
or not
DYNABARREL