Dexter 900BS2.5 Manual De Instrucciones página 144

FR
2. SAFETY INSTRUCTIONS
ES
4. POWER TOOL USE AND CARE
PT
a) Do not force the power tool. Use the correct power tool for your application.
The correct power tool will do the job better and safer at the rate for which it was
IT
designed.
b) Do not use the power tool if the switch does not turn it on and o . Any power
EL
tool that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or remove the battery pack, if
PL
detachable, from the power tool before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk
UA
of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
RO
unfamiliar with the power tool or these instructions to operate the power
tool. Power tools are dangerous in the hands of untrained users.
EN
e) Maintain power tools and accessories. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that may a ect the
power tool's operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations di erent from those intended could
result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease.
Slippery handles and grasping surfaces do not allow for safe handling and control of the
tool in unexpected situations.
5. SERVICE
a)
Have your power tool serviced by quali ed repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
EXTRA SAFETY REGULATIONS CONCERNING BELT SANDER
• Hold the power tool by insulated gripping surfaces, because the sanding
surface may contact its own cord. Cutting a "live" wire may make exposed metal
parts of the power tool "live" and could give the operator an electric shock.
144