Safety Instructions; Intended Use; Items Supplied; Overview Of The Appliance - lidl KH 1151 Instrucciones De Uso

CEILING FAN KH1151

Safety instructions

Danger:
Always follow the safety instructions below.
Otherwise, there is a significant risk of accidents.
Risk of electric shock
• Only a qualified electrician may connect the appliance to a properly
installed and earthed power supply with a mains voltage of 230 V ~
at 50 Hz.
Never submerge the appliance in liquid, never subject it to moisture
and never use it outdoors. Should liquid nevertheless enter the ap-
pliance housing, disconnect the appliance from the power source,
for instance by removing the associated building fuse or switching
the corresponding circuit breaker (off position) in the fuse box.
• Do not kink or crush the power cable.
• If the power supply wire or the appliance housing are damaged, you
must have the appliance repaired by an expert before using it again.
You may not open the appliance housing. Should you do so, appliance
safety can no longer be assured and the warranty will become void.
Risk of fire
• Do not leave the appliance unattended when in use.
• Never hang the appliance in the vicinity of heat sources.
• Do not connect the ceiling fan through a dimmer switch.
Use only the pull chain provided for changing the rotation speed.
Injury hazard
•This appliance is not intended for use by individuals (including children) with
restricted physical, physiological or intellectual abilities or deficiences in
experience and/or knowledge unless they are supervised by a person
responsible for their safety or receive from this person instruction in how
the appliance is to be used.
• Children should be supervised to ensure that they do not play with the
appliance.
• The minimum distance from the tips of the blades to the floor must be
2.30 m when installed. • The distance between the blades and the ceiling
must be at least 0.30 m. The side distance to room walls or obstructions
must be at least 0.60 m (see Fig. 1).
Fig. 1: Minimum distances for the ceiling fan
• No obstructions may be located within the rotation range of the appliance.
• The appliance must be securely fastened to the room ceiling. The ceiling,
pins and screws must be capable of supporting the additional load pro-
duced by the rotation of the appliance. If necessary, seek advice at a
building supplies store regarding the mounting of the ceiling fan.
Risk of choking
• The appliance may not be operated in combination with an oil or gas
oven or heater. Exception: the smoke outlet has been inspected and ap-
proved by an expert in consideration of the fan operation.

Intended use

The ceiling fan serves exclusively for promoting circulation. This ceiling fan
is intended exclusively for use in private households. Observe all information
in this installation and operating manual, in particular the safety instructions.
Any other use is considered improper use.

Items supplied

1x Motor in the motor housing
1x Light module with bulb holders
4x Blades
4x Blade holders
4x Fixing plates
4x Fixings
1x Ceiling attachment with covering
2x Extension rod
1x Cover
1x Bulb 60 W G9
Assembly video (SVCD)
Operating instructions

Overview of the appliance

1 Covering
2 Extension rod (2 variants)
3 Cover
4 Fixing
5 Sliding switch for changing the direction of rotation
6 Pull-chain for changing the rotation speed
7 Illumination cover
8 Pull-chain for illumination
9 Blades (4 pieces)
0 Motor housing
q Blade mounts (4 pieces)
w Fixing plate
e Installation plate

Product Description

This ceiling fan has three speed levels that are controlled with the pull chain 6.
The sliding switch for changing the direction of rotation 5 enables a change
to be made to the direction of rotation, so that air can be swirled either up-
wards or downwards. In addition, the fan is equipped with a light, this light
is switched on and off with a separate pull-chain 8.
- 26 -