Operation; Adjusting Velocity And Light; Selecting The Direction Of Rotation - lidl KH 1151 Instrucciones De Uso

Colour coding:
Green-yellow (I): PE conductor
Blue (II): Neutral conductor
Brown (III): Current-carrying wire (also: black)
Connect the electrical wires
Step 1: Connect the PE conductor to the lamp-wire connector (I).
Step 2: Connect the blue wire (N) (II).
Step 3: Connect the brown wire (L) (III).
Connect the cable plug
Connect the cable plugs of the two PE conductors of the fan with the sockets
on the installation plate e.
Then connect the wide cable plug of the fan to the socket on the installation
plate e.
4. Click the covering 1 into the installation plate e: insert it into the two
adjacent bearings and snap it into the opposing spring-loaded bearing
(click!).
1
5. Switch the power supply on.
1 (I)
(II)
2
(III)
3
"KLICK"

Operation

Adjusting Velocity and Light

Adjust the speed level with the pull chain 6 on the motor housing.
Each pull changes the speed in the following sequence:
OFF - fast - medium - slow
Switch the light on with the pull-chain 8.
If the fan is also to be switched on and off with a separate switch or a
circuit breaker, it will start at the last speed set, unless it was switched off
using the pull chain 6.

Selecting the Direction of Rotation

Advice about fan rotation
The fan turns anti-clockwise:
Classic fan function. The downward air flow creates a cooling effect.
Typically used during warm times of the year.
The fan turns clockwise:
The air flow is directed toward the ceiling. The heated room air is distributed
better throughout the room and the accumulation of warm air near the
ceiling is prevented.
Caution:
To prevent damage to the fan motor, only operate the direction switch when
the fan is stopped.
Change the direction of rotation with the sliding switch 5.
Switch positions:
Switch to the right: The fan turns clockwise.
Switch to the left: The fan turns anti-clockwise.
- 30 -