stayer SC300W Manual De Instrucciones página 41

1.Provided use of the machine
This tool has been solely and exclusively designed
for:
1.Stationary works on flat and stable surface
2.Working on hard and soft wooden pieces
3.Working on chipboard pieces
4.Working on fiberboard pieces
5.Working on PVC tubes
6.Making rectilinear cuts along the length and width
of the workpiece
7.Making horizontal mitre-cuts between -45º and
45º
8.Making vertical mitre-cuts between 90º and 45º
Refer to the limits regarding the size of the
workpiece in corresponding chapter 11.
2.Unpackaging and assembling
Unpackaging
1.Cut the seal and open the box.
2.Withdraw upper cardboard stoppers
3.Extract the box by firmly grasping the operating
head and the motor body using both hands
so as to balance the weight
4.Extract the box with the accessories
5.Extract the documentation
6.Preserve the cardboard box, the stoppers thereof
and the documentation permanently in an
inventoried safe environment being easily
accessible and known to the machine
operator.
Packaging
IMAGES A B
Operation 1: Securing, folding and fastening the
operating head:
1.Place upper head at horizontally 0º by loosening
13 and locking at 0º.
ENGLISH
40
2.Place upper head at vertically 90º by acting on 4,
lowering the head and locking with 26.
3.Arrange protector 49 such that it contacts the
cutting table.
4.Push upper blocking button 4 to release the
descent of the head.
5.Lower head to the limit and position it to be able to
lock it with button 32.
6.Push lower locking button 32 to lock the head.
Operation 2: Packaging the machine
1.Locate the cardboard box.
2.Locate documentation.
3.Firmly grasp the machine by its operating head
and motor body.
4.Place the machine over the 4 circular recesses of
the bottom of the box.
5.Store documentation of the machine.
6.Position upper cardboard stoppers.
7.Close the box and fix it with sealing tape.
3.S etting or fa stening t he
machine in a stable position
1.The working area where the machine is being
arranged must mandatorily be safe.
2.Support tool in a stable position on an even
surface.
3.The base of the mitre saw has four holes for firmly
fastening the machine to the working
bench. It is strongly recommended to fix the
machine to the bench by means of the
pertinent screws and nuts.
4.Connection to the grid, wiring,
fuses, socket type for the jack and
requirements for grounding
1.For supplying electrical power to the machine,
connect the Jack to a standard socket
capable of supplying a minimum of 2500
VA .
2.The internal wiring of the machine is completely
terminated so that no wiring is needed
when installing it.
40