Operating External Components With The Remote Control; Important; Operating The Tv - JVC TH-S3 Manual De Instrucciones

Operating external components with the remote control

The buttons described below are used on pages 11 and
12.
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

Operating the TV

7 To set the manufacturer's code
You can operate a JVC TV without setting the manufacturer's code.
1
Slide the remote control mode selector
to TV.
2
Press and hold
Keep the button pressed until step 4 is finished.
3
Press ENTER.
11
Remote control
mode selector
(play button)
Number
buttons
TV.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
Manufacturer Code
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11
RCA 05
5
Release TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.

IMPORTANT

Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
TV:Turns TV on and off.
TV VOL +/–:Adjusts the volume.
TV/VIDEO:Selects the input mode (either TV or VIDEO).
CHANNEL +/–:Changes the channels.
1-10, 0, +10 (100+):Selects the channel.
TV RETURN:Alternates between the previously selected channel
and the current channel.
Manufacturer Code
Samsung 12
Sanyo 13
Sharp 06
Sony 07
Toshiba 08
Zenith 09