Faults Reference Code; Warning Indicator - Infosec E4 Serie Manual De Usuario

When input voltage is within the
acceptable range but UPS is in
overload, the UPS will enter bypass
Bypass mode
mode or bypass mode can be set on the
front panel. The alarm sounds every 10
seconds.
The UPS is shut down and there is no
Standby mode output supply power, but the batteries
may still be charged.

3-7. Faults Reference Code

Fault event
DC Bus start fail
DC Bus over
DC Bus under
DC Bus unbalance
Inverter soft start fail
Inverter circuit voltage
high
Inverter circuit voltage
Low

3-8. Warning indicator

Warning
Low Battery
Overload
Battery is not connected
Over Charge
Over temperature
Charger failure
Battery fault
Out of bypass voltage range
Bypass frequency unstable
EEPROM error
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 03 17 AA XX 209 09
Fault code Icon
01 x
02 x
03 x
04 x
11 x
12 x
13 x
Icon (flashing)
Fault event
Inverter circuit output
short
Battery voltage too high
Battery voltage too low
Over temperature
Over load
Charger failure
Sounds every second
Sounds twice every second
Sounds every second
Sounds every second
Sounds every second
Sounds every second
Sounds every second
Sounds every second
Sounds every second
Sounds every second
Fault code Icon
14
27
28
41 x
43
45 x
Alarm
38