Operating Parameters And Specifications - Kinetico Water Systems SIGNATURE SERIE Manual Del Usuario

Operating Parameters and Specifications


Installation of this product must comply with state and local plumbing
laws

Provisions for an antisiphon air gap should be part of the installation to
prevent a cross connection between the water system and the waste
system

Waste connections or drain outlets shall be designed and constructed to
provide for connection to the sanitary water system through an air gap
of 2 pipe diameters or 1 inch (25mm) whichever is larger.

Do not use on water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system, or that
contains high concentrations
matter without additional treatment steps.

It is recommended that before purchasing a water treatment unit, you
have your water supply tested to determine your actual water treatment
needs.

Kinetico recommends the use of a high quality grade pure salt (sodium
chloride) processed especially for water conditioners.

Water conditioners using sodium chloride for regeneration add sodium
to the water. Individuals who are on sodium restricted diets should
consider the added sodium as part of their overall sodium intake.
Minimum Operating Pressure: 15 psi (103.4 kPa)
Maximum Operating Pressure: 125 psi (861.9 kPa)
Maximum Working Pressure: 125 psi (861.9 kPa)
Minimum Operating Temperature: 35
Maximum Operating Temperature: 120
The Kinetico Signature Series water softener is available in three (3) tank sizes
that allow you to use the ideal configuration for your application. For specific unit
operation, please reference the performance data sheet provided by your
authorized Kinetico dealer.
Tank Size
Media Volume (per tank)
Maximum Compensated
Hardness
Backwash Flow Rate
of sediment, dirt or other suspended
o o
F (2 C)
o
F (49
Signature 735
7" x 35"
0.50 cu. ft.
40 gpg
1.4 gpm
8
o
C)
Signature 935
9" x 35"
0.75 cu. ft.
60 gpg
2.0 gpm
Signature 1035
10" x 35"
1.0 cu. ft.
80 gpg
2.0 gpm