Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE 100 HOURS.-
1. TIGHTENING THE PEDALS
Even though the pedals are already
fitted, the right-hand pedal (marked R)
screws on in a clockwise direction,
whereas the left-hand pedal (marked
L) does so in the opposite direction.
Maintenance:
-The tension of the pedal clip with the
pedal should be checked weekly,
using a 3mm Allen key to adjust the
set screw.
-Apply a little oil to the contact point of
the pedal clip with the pedal to ensure
that it locks on. -Oil to the pedal
springs regularly. (Pedal instructions
attached)
2. CHECKING THE TIGHTENING
KNOBS.-
The
tightening
loosened off and sprayed with a
lubricant to ensure that they remain
operative.
knobs
should
MAINTENANCE 200 HOURS.-
1. ADJUSTING THE TENSION
-Remove the side covers (33) and
loosen the nuts a maximum of two
turns Fig.12.
-Tighten
spanner. Make sure that the nut
rotates the same number of turns on
both sides of the machine.
-Tighten up nuts again and put the
side covers (33) back in their place.
-Whenever the tension setting on the
machine is adjusted, readjust the
brakes as well.
THE MANUFACTURER RESERVES
THE
RIGHT
SPECIFICATIONS OF ITS PRODUCTS
WITHOUT PRIOR NOTICE.
Do not hesitate to get touch with us if
be
you have any queries, by calling:
+44 0844 335 3988
service@bh-uk.co.uk
12
the
small
nuts
TO
MODIFY
with
a
THE
Publicidad
