■ IF GASOLINE IS SPILLED, move the machine away from the area of the spill and avoid creating any
source of ignition until the gasoline has evaporated.
■ DO NOT store, spill or use gasoline near an open flame, or devices such as a stove, furnace, or water
heater which utilize a pilot light, or devices which can create a spark.
■ REFUEL OUTDOORS preferably, or in well-ventilated areas. Use UNLEADED GAS ONLY.
■ DO NOT operate engine without muffler. Operating without a muffler, or with a muffler that leaks
because of rust or damage, can permit an increased exhaust noise level. Inspect muffler periodically
and replace if necessary.
■ DO NOT use this engine on any forest covered, brush covered or grass covered unmanaged land
unless a spark arrestor is attached to the muffler.
■ DO NOT operate engine if air cleaner or cover directly over the carburetor air intake is removed.
■ DO NOT choke the carburetor to stop the engine.
■ DO NOT tamper with the government springs, governor links, or other parts which may increase the
governed engine speed.
■ DO NOT tamper with the engine speed selected by the original equipment manufacturer.
■ CAUTION!!! DO NOT run at excessive speeds. Operating the engine at excessive speeds increases
the danger of personal injury.
■ DO NOT touch hot mufflers, cylinders or fins, as contact may cause burns.
■ ALWAYS pull starter chord rapidly to avoid kickback to prevent hand or arm injury.
Pump Precautions
■ NEVER allow the pump to run for more than a 3 minute period without opening the gun. (This will
cause pump damage due to excessive water temperature and void the warranty)
■ NEVER let the pump run when the machine is not connected to the water supply. (This will cause
cavitation)
■ NEVER run acid or hard caustics (such as lye) through the pump.
■ Never use chemicals or agents which are not compatible with the Buna-N and PVC (polyvinyl) or
neoprene covering of the hose. (Always use citrus based detergents.)
■ Never use water with a temperature over 140 degrees F.
■ Check for leaks. Tighten connections if necessary.
Machine Specification
MODEL
PRESSURE
NARCEA
275BAR/4000PSI
BIDASOA
350BAR/5000PSI
It is prohibited to reproduce, copy or use this document without written permission from Stock Garden Spain (GENERGY), Spain, 2009.
30
GAS POWERED PRESSURE WASHER
FLOW
ENGINE
4.0GPM/900L/H
5.0GPM/1150L/H
DIMENSION
13HP
120*84*95cm
GX670
120*84*95cm
WEIGHT
100kg
120kg