Pre-Operation Checklist; Setup & Use; Operating Instructions - GENERGY Narcea Instrucciones De Uso

Pre-Operation Checklist

■ Be sure you understand all the safety precautions and have been instructed in the safe use of the
machine.
■ Wear face and eye protection to prevent injury from spray and flying debris.
■ Wear protective gloves, rubber boots, and other protective clothing as required.
■ Understand all safety precautions and first aid for any detergent or chemical being used.
■ Check that all lines and hoses are not kinked, twisted or damaged. Replace any damaged hose.
■ Check that the machine is connected to a water supply and that the water supply is on.
■ Tighten all fluid connections securely.
■ Check that oil and fuel levels are at the correct levels before operating. (Pump use
Pump Oil. Engine use SAE 10-30W, see engine manufacturer's manual for oil change intervals.)
■ Before starting machine be sure pump is primed and air is purged from the system by allowing water
to flow through the pump.
Setup & Use
Follow these instructions for setup and use of your high pressure washer:
1. Place the machine on a solid level surface with slopes for drainage to prevent liquid build up on the
floor or surface. Position the machine so that the operator has easy access to the pressure washer and
its controls. Be sure ventilation WARNINGS are observed.
2. Check and determine that the water supply source is capable of exceeding the output in gallons per
minute of the pump. If you are drawing water from a clean static source rather than a pressure main,
the pressure washer must be primed and placed as close as possible to the water source. Be sure
the machine is placed on a solid level surface and cannot be pulled or bumped into static source. The
intake hose used must be as large as possible. When drawing water from a pressure source, you will
need a hose with 5/8" outside diameter for lengths up to 50', or a 3/4" diameter for lengths up to 100'.
3. Connect the high pressure hose to the pressure washer and tighten securely.
Operation Instructions
WARNING!!! High pressure spray, improperly used could damage the equipment you wish to clean or
the surrounding environment. Practice on scrap materials and gradually increase pressure applied to the
object by adjusting the nozzle or moving the nozzle closer to the object until it is cleaned without being
damaged.
The manufacturer does not warranty damage caused by the consumer's failure to adjust
or operate the machine in accordance with the instruction provided in the owner's manual
supplied with the machine.
It is prohibited to reproduce, copy or use this document without written permission from Stock Garden Spain (GENERGY), Spain, 2009.
32
GAS POWERED PRESSURE WASHER
Universal