Check & Maintenance; Preventive Maintenance; Troubleshooting - GENERGY Narcea Instrucciones De Uso

GAS POWERED PRESSURE WASHER
Check and Maintenance
Daily Checks
Regular inspection of your pressure washer is the key to prolonging its life. Follow these simple daily
checks religiously.
1. Check air filter for dirt and clean or replace as required.
2. Check engine oil level. (Dipstick is attached to inside of oil cap.)
3. Check engine fuel level.
4. Check high pressure hose for kinks, twists or damage. Replace any damaged hose.
5. Check that the pump oil level is within operation range on the pump dipstick or to the center of the
sight glass.
6. Check that the water supply is adequate for your machine.
7. Check water inlet screen and clean when necessary.
8. Check the chemical supply.

Preventive Maintenance

Change pump oil after first 50 hours of use or first season, then every 300 hours or as needed. Please
use the GENERGY Universal Pump Oil and follow the steps below:
1. Unthread the oil cap on the top of the pump;
2. Put a container under the pump, then unthread the drain plug on the bottom of the pump;
3. After oil drains away completely, screw the drain plug into the drain hole again, make sure the o-ring
is with the plug;
4. Refill pump oil via the top hole of the pump until the oil level is halfway up the sight glass.
5. Screw on the oil cap.
See engine manufacturer's manual for oil change intervals. (Engine uses SAE 10-30W)

Troubleshooting

WARNING: ALWAYS SHUTDOWN THE MACHINE BEFORE YOU CHECK THESE PROBLEMS
Problem
Engine will not start
Units with Oil Alert or Oil
Guard System
Engine with low power
Engine runs well at no
load but "bogs" down
under full load
It is prohibited to reproduce, copy or use this document without written permission from Stock Garden Spain (GENERGY), Spain, 2009.
Possible Cause
1. Throttle lever on/off switch
in OFF position
2. No fuel in engine
3. Worn fouled or dirty
spark plug
4. Pressure build up in pump
Engine not level or engine oil
level too low
1. Possible internal engine
problem
2. Partially clogged gun nozzle
1. Engine speed is too slow
Remedy
1. Turn throttle lever to ON position
2. Fill fuel tank or turn on fuel supply
3. Replace with factory recommended spark plug
4. Squeeze trigger on spray wand (refer to operating
instructions in owner's manual)
Place engine on level surface or fill crankcase wit h oil
(ref er t o engine manuf act urer's instruction manual)
1. Return it to an authorized engine repair center. If
engine is equipped with throttle lever, make sure
engine is running at full throttle.
2. Clean nozzle of any blockage.
1. Contact your pressure washer dealer
35