Transportation Kit Assembly (Depending On Versions); Rubber Feet - GENERGY RENT Serie Instrucciones De Uso

4.2 Transportation kit assembly (depending on versions)

Models above 4Kw carry factory
handles which do
assembly.
In models below 4Kw (inclusive),
fasten the handle with screws and
bolts as per attached figure.
Attach the handle with the fold
facing outward as shown in the
drawing, this way the handle will
not touch the front of the engine.
The pin or lock allows the handle to
be fastened in the off position.
Fastening the wheels and support feet:
According to the figure below, screw the wheel axles on the machine frame and
fasten with the nuts. Then introduce the wheels in the axles and fasten with the
washer and nut
The machine is equipped with 4 rubber feet. If using the wheels kit can often
remove the 2 feet opposite of the wheels, the machine would be seated for 2
rubber feet on
However, if the unit is normally in same place usually recommend keeping the 4

rubber feet.

NUTS
WHEEL AXLE
not require
one side and
12
PIN-LOCK
wheels on the
RUBBER FEET
other.