KENT Edge 28B Instrucciones De Uso página 8

WARNING!
–
Before using the battery charger, ensure that frequency and voltage values, indicated on the machine
serial number plate, match the electrical mains voltage.
–
Do not pull or carry the machine by the battery charger cable and never use the battery charger cable
as a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around
sharp edges or corners. Do not run the machine on the battery charger cable.
–
Keep the battery charger cable away from heated surfaces.
–
Do not charge the batteries if the battery charger cable or the plug are damaged. If the battery charger
cable is damaged, contact Kent Service Center.
–
To reduce the risk of fi re, electric shock, or injury, do not leave the machine unattended when it is
plugged in. Before performing any maintenance procedure, disconnect the battery charger cable from
the electrical mains.
–
If the machine is not working as it should, has been damaged, left outdoors or dropped into water, return
it to Kent Service Center.
–
Do not smoke while charging the batteries.
–
Always protect the machine against the sun, rain and bad weather, both under operation and inactivity
condition. Store the machine indoors, in a dry place.
–
Do not allow to be used as a toy. Close attention is necessary when used near children.
–
Use only as shown in this Manual. Use only Kent's recommended accessories.
–
Take all necessary precautions to prevent hair, jewelry and loose clothes from being caught by the
machine moving parts.
–
Do not leave the machine unattended if the main switch is not turned to "0" and without being sure that
it cannot move independently.
–
Do not use the machine on slopes with a gradient exceeding the specifi cations.
–
Do not wash the machine with direct or pressurised water jets, or with corrosive substances. Do not use
compressed air to clean this type of machine.
–
While using this machine take care not to cause harm to other people, and children especially.
–
The machine storage temperature must be between +32°F and +104°F (0°C and +40°C).
–
The machine working temperature must be between +32°F and +104°F (0°C and +40°C).
–
The humidity must be between 30% and 95%.
–
Do not use the machine as a means of transport.
–
Do not use the machine on slopes with a gradient exceeding the specifi cations.
–
Do not allow the brooms to operate while the machine is stationary to avoid damaging the fl oor.
–
In case of fi re, possibly use a powder fi re extinguisher, not a water one.
–
Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
–
Adjust the operation speed to suit the fl oor conditions.
–
This machine cannot be used on roads or public streets.
–
Do not remove or modify the plates affi xed to the machine.
–
Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
–
If the machine is used according to the instructions, the vibrations are not dangerous. The machine
vibration level is less than 98.4 in/s
–
Use only brooms supplied with the machine and those specifi ed in the Instructions for use Manual.
Using other brooms could reduce safety.
–
In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise,
request assistance from the authorised personnel or from an authorised Service Center.
–
Carefully read all the instructions before carrying out any maintenance/repair procedure.
–
To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter
of this Manual must be performed by the authorised personnel or by an authorised Service Center.
–
If parts must be replaced, require ORIGINAL spare parts from a Dealer or Authorised Retailer.
–
The machine must be disposed of properly, because of the presence of toxic-harmful materials
(batteries, plastics, etc.), which are subject to standards that require disposal in special centers (see the
Scrapping chapter).
INSTRUCTIONS FOR USE
2 2
(2.5 m/s ) (98/37/EEC-EN 1033/1995).
146 3082 000(2)2007-06
Edge 28B
ENGLISH
5