Rheem RXAC Manual De Uso página 35

"ELE.H" button
15.
(Only for heat pumps with additional electrical supply).
In heating mode, pressing this button will change the operating mode, using the
additional electrical supply.
"Anti-FUNGUS" button
16.

Pressing this button turns the "Anti-FUNGUS" function on or off.

This function can be activated with the remote control when the unit is in
cooling, dehumidification and automatic (cooling and dehumidification)
mode.

The fins that guide the flow of air go back to their initial position in cooling
mode. If the air conditioner is in heating mode,
three minutes at low speed before stopping.

The purpose of this function is to dry the heat exchanger in the indoor unit,
and thus prevent condensation which can cause mould and bad
"SPOT SWING" button
17.
When this button is pressed, the horizontal fins start to swing automatically.
the fins reach the desired position, press the button again so they are fixed in the
selected position.
"ECO" button
18.
In cooling mode (COOL), pressing the "ECO" button turns this function on or off.
When the "ECO" function is on, the air conditioner gives priority to efficient operation
NOTE:
a. This function is not factory-set. You can turn it on or off as
you wish. To activate it, follow these steps: with the air
conditioner and the remote control set to "OFF", point the
remote control at the indoor unit and hold down the "Anti-
FUNGUS" button.
indicate that the function is
been enabled, unless you turn off the air conditioner
completely or turn off the function manually, the air
conditioning keeps this default function.
b. To turn off this function, follow these steps:
Completely shut down the air conditioner. With the air
conditioner and the remote control set to "OFF", point the
remote control at the indoor unit and hold down the "Anti-
FUNGUS" button. The unit will first emit five beeps, then
three, indicating that the function has been disabled.
c. If the function is activated, it is advisable not to turn the air
conditioner back on before the function has completely
finished.
d. This function is not activated when the timer is activated or
in night mode (SLEEP).
The unit emits two series of five beeps to
ready. Once this function has
the indoor unit fan runs for
smells.
When