SET UP
The steam hose with steam gun must be connected to the appliance, and the
desired accessory must be attached before the Brio 225CC can be used.
Start by connecting the steam hose to the steam socket on the front of the Brio
225CC. To do this, flip the cover flap down, align the steam hose with the bottom
notch and push the connector of the steam hose firmly into the steam socket until it
clicks into place (Fig.4).
To remove the steam hose, press in both release buttons on the right and left hand
sides of the steam connector and pull it out from the steam socket (Fig.5).
Assemble the extension hoses if the steam cleaner is to be used to clean floors or
difficult to reach areas. To do this, push the open end of a tube into the steam gun
until the release button of the steam gun clicks into place (Fig.6). Add one, or two
extension tubes if required. Press in the appropriate release button and pull the
tubes apart with a downward movement to take the extension tube off again (Fig.7).
The floor nozzle is delivered with a separate connector.
Assemble the connector as illustrated. Attach the floor
nozzle to the end of the extension tube. Ensure that
the nozzle clicks into place on assembly (Fig.8).
08