TOPPING UP WITH WATER
The tank must be topped up if the steam flow emitted starts to decrease. Switch
off the steam cleaner by pressing the On/Off switch. The green operating pilot
lamp goes off. Press the steam button on the steam gun to release the remaining
pressure and then lock the gun. Remove the main plug from the socket and allow
the appliance to cool down. Remove the tank cap by pressing it down and turning
it counter clockwise.
WARNING
Hot steam may escape on opening! There is a risk of burns from the cap thread
and the tank!
Top up with water using the measuring jug and funnel (see page 10, Filling the
Water Tank), then carefully close the tank cap again. The steam cleaner can now
be plugged in again and switched on. The 225CC is ready for use as soon as the
heating pilot lamp goes off.
When finished switch the appliance off. The green operating pilot lamp goes
off. Press the steam button on the steam gun (Fig.22) to release the remaining
pressure. Secure the steam gun by pushing the locking pin on the left—hand side
of the handle into the right. Remove the plug from the socket and allow the appli-
ance to cool down. Empty the water tank so that no deposits can settle (Fig. 23).
Do not close the water tank until it has dried out completely. The steam cleaner
must cool down completely before being put away. Store the appliance so that it is
out of the reach of children. The extension tube with assembled floor nozzle may
be inserted in the parking holder on the back of appliance for storage purposes or
for short breaks while working.
14