Parkside PFDS 33 B2 Instrucciones De Montaje página 39

It is recommended that you always carry out
work with another person.
I
Push the flux-cored wire through the wire outlet
(see Fig. J).
26
J
Lead the wire along the feed roller
then push it into the cable assembly intake
(see Fig. K).
K
Pivot the pressing roller unit
of the feed roller
Mount the adjusting knob
Adjust the counter-pressure using the adjusting
knob in such a way that the welding wire sits
tightly between the pressing roller and the feed
roller
squashed (see Fig. L).
L
26
and
29
Switch the welding unit on using the main
31
switch
Press the burner button
Now the wire feeder system will push the weld-
ing wire through the cable assembly
the burner
As soon as the wire protrudes 1 – 2 cm from
the torch neck
button
31 29
28
(see Fig. L).
29
27
in the upper duct without being
29
29 28
.
5
.
12
.
11
you can release the burner
32
once more (see Fig. M).
12
Assembly
in the direction
(see Fig. L).
27
and
13
GB/IE 39