Programs; Programs Pre-Recorded; Program No. 1; Program No. 40 - Decontamination Program - Ugin e.ON SINTER Manual De Instrucciones

Instructions for use (rev 05/18)

6.6. Programs

6.6.1. Programs pre-recorded

Two programs are pre-recorded in the furnace:

6.6.1.1. Program No. 1

6.6.1.2. Program No. 40 – Decontamination program
A decontamination program must be carried out as a precautionary measure before the first use
of the furnace: start the pre-recorded program number 40.
If use different types of zirconia, zirconia of different brands or zirconia with different sintering
temperatures (even during separate sintering cycles) it may be necessary to carry out regular
decontamination of the furnace e.ON SINTER using the cycle recorded in number 40.
UGIN DENTAIRE
Program No 1
Stage Temperature (°C)
1 C1: 50
2 C2: 300
3 C3: 600
4 C4: 1000
5 C5: 1200
6 C6: 1200
7 C7: 1450
8 C8: 1450
9 C9: 1200
10 C10: 1200
Decontamination cycle - n° 40
Stage Temperature (°C)
1 C1: 50
2 C2: 300
3 C3: 1000
4 C4: 1590
5 C5: 1590
6 C6: 900
Time (minutes)
T1 : 25
T2 : 40
T3 : 40
T4 : 20
T5 : 10
T6 : 25
T7 : 30
T8 : 30
T9 : 30
T10 : -121
Time (minutes)
T1 : 40
T2 : 70
T3 : 150
T4 : 60
T5 : 70
T6 : -121
e.ON SINTER
37