(6) 1 Uncoil enough nails to reach the driving hole.
2 Insert the fi rst nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving Hole Guide Slot
First Nail
2
Nail Guide
2
NOTE: Be careful not to deform the collated wires
and not to disengage the nails with the guide
surface.
Otherwise, the nail guide will not close
correctly.
4 Pulling the nails to the right, swing the nail guide
closed.
(7) Lock the knob completery.
NAILER OPERATION
Read section titled "SAFETY" (pages 4 – 8).
● Operators and others in work
● Only person who have read
● NEVER point tool at yourself
● Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
● Know and understand what trigger system
you are using.
3
Guide Surface
Feeder
DANGER
area
MUST
wear
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
and
understand
MANUAL should operate the
Nailer.
or others in work area.
Please read and understand "Methods of
Operation" below.
● Never place your hands or body closer than 8
inches (200 mm) from fi ring head when using.
● Do not drive nails into other nails; nails can
ricochet and hurt someone.
● Do not actuate Nailer unless Nailer is placed
fi rmly against the workpiece.
4
● In order to avoid double fi re or unwanted
ejection of a nail due to bouncing of the Nailer,
1
1) do not push Nailer on workpiece with strong
force;
2) take Nailer away from workpiece using
recoil;
3) release trigger quickly when performing
trigger fi re.
● When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
which may cause injury.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Nailer which is defective or
operating abnormally.
● Do not use the body or any portion of the
tool as a hammer as nails may be discharged
unexpectedly or the tool may become
damaged and serious injury could occur.
● Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
safety
3) elevating, lowering or otherwise moving it
to another location;
4) handing it to another person;
5) performing any maintenance or repairs;
6) clearing a jam;
7) Nailer is outside of the operator's
supervision or control;
8) removing nails from the magazine; and
9) adjusting nailing depth.
this
This metabo HPT nailer has a STANDARD CONTACT TRIP
MECHANISM (Bounce Fire). An OPTIONAL SEQUENTIAL
TRIP MECHANISM kit (SINGLE SHOT) is available as
order part number 876762.
THE STANDARD CONTACT TRIP MECHANISM (Bounce
Fire) is for use where rapid fastener placement is desired
and must be operated in accordance with the following
"METHODS OF OPERATION".
English
17