Settings - Festool TURBO II M - 8 WP Manual De Instrucciones

Turbo II M
GB
Failure code Failure D
E
F4 Temp. high
F5 Temp. low
F6 Temp. sen-
sor
F7 Pressure
sensor
F8 Controlunit
F9 Electronic
F10 Control
F11 Power Sup-
ply on
F11 Power Sup-
ply off
F12 Temp. high
F13 Calib. P
F14 Temp. sen-
sor
F15 On-Button
Other failures
Failure
No function
No / poor dedusting function Air pressure to low
No / poor extraction
8

Settings

The following settings can be made using the but-
tons:
24
Significance
Temperature in motor terminal box
too high.
Device temperature too low.
Temperature sensor in terminal box
defective.
Pressure sensor defective
Control unit fault
Electronic fault
Fault message from FC.
Fault with the power supply
Fault with the power supply
Temperature of blower nozzle too
high
Fault with pressure sensor calibration Try to restart.
Temperature sensor at blower nozzle
defective.
Button faulty ON-Button
Cause
Mains supply defective
Fuses have tripped
ground fault circuit interrupter has
tripped
Check solenoid valves
Fuses defective
Internal hose rupture
Leakage at the trap or pipe system
Solution
Reduce ambient temperature., pro-
vide better cooling.
Contact service if fault occurs again.
Increase ambient temperature
Contact service if fault occurs again.
Contact Service.
Check/ replace vacuum hoses.
Contact service if fault occurs again.
Contact Service.
Contact Service.
Contact Service.
Check/ replace fuses.
Contact service if fault occurs again.
Check/ replace fuses.
Contact service if fault occurs again.
Reduce ambient temperature., pro-
vide better cooling.
Contact service if fault occurs again.
Contact service if fault occurs again.
Contact Service.
Contact Service.
Solution
Check, repair if necessary.
Check vacuum hoses.
Increase air pressure.
Contact Service.
Check, replace if necessary (see
chapter 10.5).
Contact Service.
Check.
[1-2] Operating buttons
[1-4] Return key
[1-5] Enter key