Master Switch; Indicator Lighting System; Usb Socket; Ethernet Socket - Kemper AirWatch Manual De Uso

KEMPER AirWatch operating instructions - EN

1.1 Master switch

The master switch isolates the AirWatch power supply completely from the mains.

1.2 Indicator lighting system

At the sides of the device, there are three signal lights in each case, reminiscent of a
traffic light. Their function is to display the current air quality.

1.3 USB socket

The USB socket is used to extend the AirWatch by a WLAN interface. This is in the
deliverables.
N.B.: Please - always leave the Wi-Fi adapter plugged in to the device over the entire
time it is in operation!

1.4 Ethernet socket

This network interface can be used for cabled integration of the AirWatch in an
existing network. The AirWatch accepts RJ45 Ethernet cables. The connection for
this is on the normal switch/hub or router equipment or directly to a terminal device.

1.5 Reset button

The reset button resets the settings and calls up the WLAN access point once more.

1.6 Inspection cover

To remove the AirWatch memory board (carries firmware), there is an inspection
cover on the side of the AirWatch. The cover is removed from the main casing by
loosening 4 screws.
Part no.: 150 2608 - 43 - Rev.: 00
Issue: 03/2017
All rights over changes without prior notice and errors reserved.