Call Setup; Problem With The Call; Wifi/Wlan; Manual Ip Addresses - Kemper AirWatch Manual De Uso

KEMPER AirWatch operating instructions - EN
Access Point mode is the preferred choice if, for example, the aim is to demonstrate
the AirWatch function, if the place of operation of the AirWatch should change
frequently, even if you have no separate network infrastructure.

2.8 Call setup

If you have selected your desired type of connection and configured this optionally,
then you can confirm the inputs by means of the "Connect/Call" button. On this, the
AirWatch restarts with the updated configuration.

2.9 Problem with the call

2.9.1

WiFi/WLAN

Should the AirWatch have been unable to connect with the selected WLAN network,
the "AirWatchAP" access point continues in existence. You must rerun configuration.
In this case, errors are usually based on incorrectly entered passwords.
Should the AirWatch not be connected with the WLAN despite the password being
correct, then it may be the case that the WLAN network is not supported in its
configuration by AirWatch. In this case, please select a different WLAN network, or
use the cabled connection as an alternative.

2.9.2 Manual IP addresses

If an error has occurred during manual entry of the IP configuration, then this is not
detected by AirWatch as an error, as the connection can still be made (despite
incorrect entry).
To correct an incorrect entry, you must reset the AirWatch network configuration via
a network reset in the factory state.
Part no.: 150 2608 - 53 - Rev.: 00
Issue: 03/2017
All rights over changes without prior notice and errors reserved.