Operating Instructions - Table of Contents
1 About this document
2 Safety
3 Operation
4 Error messages
5 Troubleshooting
1
About this document
1.1 Purpose of the document
This operating instructions are part of the product and
provides the user with information on the safe operation
of the unit.
1.2 Using this document
X
Read these operating instructions before operating
the unit.
X
Keep these operating instructions ready to hand.
X
Hand these operating instructions on to the following
owner or user of the unit.
1.3 Use of symbols and highlighting
Explanation
Action to be taken
Requirements for the following necessary ac-
tion
Note on a special technical feature
Separate information is available
Possibility on property damage
Possibility on a severe or mortal injury
1.4 Warranty and liability
Webasto shall not assume liability for defects or damage
that are the result that the installation and operating in-
structions as well as the instructions contained therein
being disregarded.
This liability exclusion particularly applies for:
■ Improper use
Frigo Top | Pordoi | Rolle
2
6 Notes on good practice
2
7 Technical support / customer service
3
8 Disposal
7
7
■ Repairs not carried out by a Webasto service work-
shop
■ Use of non-genuine parts
■ Conversion of the unit without permission from
Webasto
■ Mechanical damage to the equipment
■ Failure to comply with inspection and maintenance
instructions
ATTENTION
Misuse as a result of failure to comply
with the operating instructions
Result: damage to the Transport Refrigeration
■ Follow the operating instructions.
2
Safety
2.1 General safety
Please note that the configuration of the insulation/cool-
ing affects the storage capacity of the vehicle. When
making use of the maximum storage capacity and the
seats, please also comply with the permissible axle load.
2.2 Intended use
The system is designed for cooling the load compart-
ment of commercial vehicles while driving. The Frigo
Top (S), Pordoi and Rolle can be equipped with a Stand-
by function
To safeguard the system, the refrigeration
system must be run for a few minutes at least
once a week (in all weather). In addition, the
inspection and maintenance intervals must
be respected.
The performance values of your application
are closely related to ambient conditions, ve-
hicle insulation, etc. The actual temperature
may therefore deviate from the set value.
7
8
8
2