EGEA
90LT - 120LT
1.3 Copyright
These operating instructions contain information protected by
copyright. No part of these operating instructions may be pho-
tocopied, duplicated, translated or recorded on storage media
without prior permission from the supplier. Any violations will be
subject to compensation for damage. All rights, including those
resulting from the granting of patents or registration of utility
models, are reserved.
1.4 Available versions and configurations
This equipment is a 0.83 kW air-water heat pump for domestic
hot water heating, available in versions with 90 L tank and 120
L tank.
Version
Configuration description
90LT
Air heat pump for domestic hot water (DHW) production
120LT
2. HANDLING AND TRANSPORT
if using knives or cutters to open the cardboard packaging.
After removing the packaging, check the integrity of the unit. If
in doubt, do not use the unit; contact authorized technical per-
sonnel.
Before eliminating the packaging, according to the applicable
environmental protection regulations, make sure all the acces-
sories supplied have been removed.
ATTENTION!: The packaging materials (clips,
cardboard, etc.) must not be left within the reach
of children as they are hazardous for them.
(*) Note: The type of packaging may undergo variations at the
discretion of the manufacturer.
For the entire period the equipment remains idle, awaiting com-
missioning, it is advisable to put it in a place protected from
atmospheric agents
2.1 Receipt
In addition to the units, the packages contain accessories and
technical documentation for use and installation. Check that the
following are present:
• User, Installation and Maintenance Manual
• Safety valve
• 6-core cable digital inputs
For the entire period the equipment remains idle, awaiting com-
missioning, it is advisable to put it in a place protected from
atmospheric agents.
cod. 3541T580 - Rev. 00 - 12/2019
The equipment comes in a card-
board box on a wooden pallet.
For unloading operations use a
forklift or pallet truck having a load
capacity of at least 250 kg. The
packaged equipment must be kept
upright during all loading operations.
Unpacking must done carefully so as
not to damage the equipment casing
EN
73