Before Operation; Setting The Clock - Aiwa CSD-EL300 Manual De Instrucciones

BEFORE OPERATION

To turn the unit on
Press one of the function buttons (TAPE/REV MODE,
TUNER/BAND, CD).
Playback of the inserted disc or tape begins, or the
previously tuned station is received (Direct Play Function).
The POWER button is also available.
Pressing the z CD OPEN button turns the unit on as well.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
NOTE
When using on the batteries, you cannot turn the power on
with the remote control.
To use the headphones
Connect headphones with a stereo mini plug (ø3.5 mm,
inch) to the PHONES jack.
No sound is output from the speakers while the headphones
are plugged in.

SETTING THE CLOCK

When the power code is plugged into an AC outlet for
the first time after purchase, the clock display flashes.
1
Press the CLOCK button.
5 flashes.
2
Turn the VOLUME/TIMER control to adjust the
clock.
For quick adjustment, turn the control quickly.
You can also press the f or g button. Holding
1 /
these buttons down will vary the time in 20-minute units.
8
3
Press the ENTER or a button to complete the
setting.
5 on the display disappears and the clock starts from
00 seconds.
To display the current time
Press the CLOCK button.
To return to the operation display, press the CLOCK button
or one of the function buttons.
To switch to the 12/24-hour standard
While the clock is displayed, press the s button.
In the 12-hour standard, "AM 12:00" indicates midnight
and "PM 12:00" indicates noon.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time
needs to be reset.
If power is interrupted for more than approximately 12 hours,
all settings stored in memory after purchase need to be
reset.
(12-hour standard)
En
E
F
5
ENGLISH