Sound; Adjusting The Sound - Aiwa CSD-EL300 Manual De Instrucciones

SOUND

ADJUSTING THE SOUND

VOLUME CONTROL
Turn the VOLUME/TIMER control on the main unit or
press the VOLUME buttons on the remote control.
The volume level is displayed as a number from 0 to
MAX (31). The volume level is automatically set to 21 if
the power is turned off when the volume level is set to
22 or more.
To display the current volume level
Press the DISPLAY button on the remote control.
The volume level is displayed for 4 seconds.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press the T-BASS button.
To cancel, press the button again.
NOTE
Low frequency sound may be distorted when the T-BASS
system is used for a disc or tape in which low frequency
sound is originally emphasized. In this case, cancel the T-
BASS system.
Q SURROUND SYSTEM
The Q SURROUND system built into this unit uses only two
speakers at the left and right to create an atmosphere that
sound as if you are surrounded by two front speakers and
two rear speakers.
Press the QSURROUND button.
To cancel, press the button again.
NOTE
• The Q SURROUND system does not work in monaural
mode.
• At higher volumes, turning Q SURROUND on may cause
sound distortion. In this case, turn the volume down.
6
ENGLISH
EQUALIZER MODE
Press the 3-MODE EQ button on the unit or the EQ
button on the remote control repeatedly.
The mode changes to the ROCK, POP, JAZZ or normal
mode cyclically.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
JAZZ: Accented lower frequencies for jazz-type music