Radio Reception; Manual Tuning - Aiwa CSD-EL300 Manual De Instrucciones

RADIO RECEPTION

MANUAL TUNING

1
Press the TUNER/BAND button repeatedly to
select the desired band.
FM
If the power is turned off, the previously tuned station will
be played (Direct Play Function).
2
Press the f or g button to select a station.
Each time the button is pressed, the frequency changes.
During FM stereo reception, "STEREO" is displayed.
To search for a station quickly (Auto Search)
Keep the f or g button pressed until the radio starts
searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the f or g
button.
• The Auto Search may not stop at stations with very weak
signals.
For better reception
FM
Extend the FM antenna and orient it for the best reception.
AM
The AM antenna is inside the unit. Position the unit for the
best reception.
8
ENGLISH
AM
Frequency
When an FM stereo broadcast contains noise
Press the MODE button on the remote control.
MONO appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button on the unit.
To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations
(see "PRESETTING STATIONS") are cleared. The preset
stations have to be set again.