Removing And Refitting The Metal Grease Filter - Gaggenau VL 414 111 Instrucciones De Uso

By hand:
Note: You can use a special grease solvent for
stubborn dirt. It can be ordered via the Online Shop.
▯
Soak the metal mesh grease filters in a hot soapy
solution.
▯
Clean the filters with a brush and then rinse them
thoroughly.
▯
Leave the metal mesh grease filters to drain.
Removing and refitting the metal
grease filter
Removing the metal grease filter
1 Bring the locking mechanism to the mid-position
and pull it upwards and out. The locking
mechanism snaps out of the holder.
Notes
‒ Use a tea towel to remove the locking
mechanism.
‒ Risk of scratching when lifting out and setting
down. Lift the locking mechanism straight
upwards and do not tilt it.
2 Twist both retaining brackets upwards. Press the
retaining brackets together slightly and
downwards so that the metal grease filter loosens
from the detent. Pull the metal grease filter
upwards and out of the appliance.
3 Clean the metal grease filter.
4 Clean the inside of the downdraft ventilation.
Installing the metal grease filter
1 Press the metal grease filter downwards until it
snaps into the lateral detents.
2 Twist both retaining brackets downwards.
3 Press the locking mechanism downwards in the
mid-position until it snaps into the two lateral
detents with an audible "click".
Note: The " symbol on the locking mechanism
must be at the front.
11