ECOFOREST HIDROCOPPER Manual De Usuario página 22

1-4c Thermostat
Standby
Example: If you wish the temperature sensor (thermostat) to control the start and stop of the boiler through
room temperature, put the Stand-By by thermostat on position YES. This function is only recommended in case of
minimal temperature decrease in the house (2°C within 24 hours) as repeated starts and stops may damage the
boiler.
If you wish the boiler to turn on at a higher level than set by default, (level 5) change it at point 1-5, to reach
this point, follow previous steps that is, press MENU (
1-5 Pellets
level programming
1-5 5 _ _ _
level programming

If you press On (
Combustion air adjustment.
Important: if you request a password to enter, this will be .
1-6 Combustion
air adjustment
1-6a Air combus.
adjustm. .00 mB
If you press MENU (
1-6b Adjust turn
extract.
Only in air models. If you press MENU (
1-6c Fan speed
adjustm.

If you press On (
Multiple use settings.
1-7 Other uses
programming
If you activate this MENU when room temperature you settled goes beyond
2°C, the boiler will stop and turn on after room temperature would have gone
down and after the boiler gets cold. In order to activate it, press the increase
NO

button ( ) and you will see on the screen that it is activated by an "S"
between fuel level and room temperature.
When this screen is displayed, press MENU (
Programming has to be made through the increase/decrease buttons

( ). Pellets drop level at which you wish the boiler to turn on (1, 3, 5, 7,
9). To exit, press On button (
) you get back to the main screen and if you press increase (
Though the boiler adjusts automatically, fine-tuning might be necessary, for
example, lack of cleaning, dirty heat exchanger, fire-basket full of ash, etc.
Setting is easy: when point 1-6 is displayed, press MENU (
following appears:
Actual combustion air level in millibars, to adjust it, increase it through (
decrease it through (
related to gas outlet pipe or excessive drawing. It can be increased (+ 0.09) or
decreased (- 0.09) through 9 levels. To exit press On (
point 1-6 Combustion air setting.
)
:
In this menu, set the extractor rotation manually: by pressing
increase/decrease buttons (
00%
of the extractor – read point 1-7a air setting – carefully.
) :
In this menu, set the extractor rotation manually: by pressing
increase/decrease buttons (
00%
the convection fan.
) you get back to the MENU and if you press the increase button (

Press MENU (
 
) twice and increase (
 ), you get back to point 1-5 pellets level.

). This setting is necessary only in case of problems
 ) you will increase or decrease the power

) you will increase or decrease the speed of
) and you reach this menu.
21
) until the following is displayed:

).

) you enter menu 1-6
)

) and you get back to

) you reach menu 1-7
and the

) or