Adjusting The Spray Pattern; Spraying Instructions; Air Blowing Nozzle - Homeright FINISH MAX PRO Manual De Instrucciones

ADJUSTING THE SPRAY PATTERN

By turning the wings of the tip, the Finish Max Pro Fine Finish Sprayer sprays in one of two
patterns: horizontal or vertical. (See Figure D.) DO NOT engage the trigger while turning the tip,
and be sure not to spray toward you, as this could cause injury. (See Figure C & D)
NOTE: The Finish Max Pro air cap is adjustable 360° for a spray pattern at any angle
(not just vertical or horizontal). If the air cap is difficult to rotate, the user should loosen the black
air nut collar around it.

SPRAYING INSTRUCTIONS

Caution: Do not twist electrical cord. Make sure heavy objects are not placed on it.
Keep electrical cord away from heat and sharp objects. To avoid a tripping hazard,
make sure cord is not in a heavy traffic area. Do not use the cord if it is damaged.
Use appropriate breathing protection, eye protection, gloves and clothing.
1. Make sure the container is empty and dry.
2. Pour paint or stain into the container. (See Thinning Instructions)
3. Be sure the pick-up tube is inserted tightly in the intake port and the tube's angle
is as you want it. (Figure E.)
4. Affix the container to the sprayer by turning the container counterclockwise.
5. Refer back to "Practice First" on pg 6. Follow Steps 5 thru 8, keeping in mind you are now
spraying paint or stain. If, after making adjustments, you still are not satisfied with the spray
pattern, refer to TROUBLESHOOTING on page 10.
6. Hold the sprayer 4 to 10 inches from the surface to be painted. While the angled pick-up
tube permits you to spray in an upward or downward direction, try to tilt the sprayer as little
as possible. Do not tip more than 45 degrees when motor is switched off.
7. Overlap each stroke by about 1/3 of the spray pattern.
NOTE: If you stop spraying for 30 minutes or longer: Before continuing, retest the spray pattern
by spraying on newspaper or cardboard. If you are unable to adjust the spray pattern properly,
it is possible the stain or paint material has started to dry. If this happens, clean the sprayer.
See CLEAN UP INSTRUCTIONS.
NOTE: If the spray pattern still is not correct, you may need to thoroughly clean the nozzle and
needle. To keep the unit spraying properly, you should expect to clean it after dispensing each
five to nine gallons of paint or stain. After cleaning, reassemble the parts.

AIR BLOWING NOZZLE

The air blowing nozzle is a breeze-dusting device, suitable for dusting computer heat sinks,
keyboards, air conditioner filter meshes and all kinds of precision instruments. (See Figure F.)
However it is NOT suitable for liquid spraying.
HOW TO USE (CONTINUED)
FINISH MAX PRO FINE FINISH SPRAYER
(C800850)
8
C
D D
E
F
ENGLISH