Hama TH-200 Instrucciones De Uso página 4

Note
• The product is usually in clock mode. If the product is in another mode, press the
MODE button (3) until it is in the mode you want.
• When you adjust the settings, the selected item will flash to indicate that it can
be set.
5.1 Setting the time format/time
• In clock mode, press and hold the MODE button (3) for about 4 seconds to start
setting the time:
• Hours
• Minutes
• Press the UP (6) or DOWN (7) buttons to select the individual values.
• Press the MODE button (3) to adopt the set value displayed and skip to the next
item.
• Press the MODE button (3) to save the settings and return to the normal display.
5.2 Setting the calendar
• In calendar mode, press and hold the MODE button (3) for about 4 seconds to
start setting the calendar:
• Year
• Month
• Day
• Press the UP (6) or DOWN (7) buttons to select the individual values.
• Press the MODE button (3) to adopt the set value displayed and skip to the next
item.
• Press the MODE button (3) to save the settings and return to the normal display.
Note
• The weekday is set automatically when setting the date manually.
• If you do not make an entry for several minutes, you automatically exit the setup
mode. The settings that were made up to that point are not saved!
5.3 Switching between the 12/24-hour display formats
Press and hold the UP button (6) for about four seconds to switch between 12-hour and
24-hour time formats, AM or PM appears before the time.
5.4 Setting the alarm
• Repeatedly press the MODE button (3) to enter alarm mode.
• Press and hold the MODE button (3) for about four seconds to start setting the
alarm.
• Hours
• Minutes
• Press the UP (6) or DOWN (7) buttons to select the individual values.
• Press the MODE button (3) to adopt the set value displayed and skip to the next
item.
• Press the MODE button (3) to save the settings and return to the normal display.
5.5 Temperature measurements, maximum/minimum display
• Press the DOWN button (7) when in any mode to choose between °C (Celsius) and
°F (Fahrenheit).
• Press the MAX/MIN button (4) to display the maximum or minimum recorded values
for temperature and humidity.
5.6 Alarm
• In time or calendar mode, press the UP button (6) to switch the alarms on or off. If
one of these symbols appears on the display, the relevant functions are activated.
• If the alarm is switched on, it will stop going off automatically after about 1 minute
or when the SNZ (5) or LIGHT (8) button is pressed. If you press the SNZ button (5),
the alarm will go off again four times.
5.7 Temperature trend display (2)
This display shows the temperature trend over the last 12, 6, 3, 2 or 1 hour(s), within a
max. range of +/- 3 °C or +/- 5.4 °F. It is only for informational purposes; you cannot
make any settings on this display.