RotoZip DR1 Instrucciones De Funcionamiento Y Seguridad página 9

RZ 2610011339 01-10:RZ 2610011339 01-10 2/3/10 11:16 AM Page 9
Step 1: Be certain that the box or fixture is
firmly mounted and all wires or other
obstructions around the opening are pushed
back out of the way. The bit uses the outer
edge of the box or fixture as a guide, so it is
important that there is nothing in the way
which can prevent it from guiding completely
around the opening. For the purposes of this
instruction manual, the procedure discussed
will be to make a cut-out around a standard 2
1/8" x 3 3/4" electrical box.
Step 2: Slide switch to turn the tool on. While
holding the Drywall Router firmly with both
hands, plunge the bit through the mark you
made. Then guide the bit to the right until you
feel and hear the bit touch the inside edge of
the box (Fig. 8).
FIG. 8
Step 3: Pull the bit out far enough to slip it
over the edge of the box so it is now against
the outside of the box (Fig. 9).
Step 4: While keeping the bit in contact with
the outside of the box move the tool counter
clockwise while applying light inward and
upward pressure until you feel and hear it
come to the corner. As you round the corner
apply light pressure left and downward (Fig. 9).
Step 5: While moving slowly and continuously
along the top contour you will feel the bit come
to the next corner. Round the corner and
apply light down and inward pressure until the
bottom corner is reached (Fig. 9).
Step 6: Move the bit right and upward
maintaining light continuous pressure toward
the box (Fig. 9).
Step 7: Round the right bottom corner and
begin moving the bit upward while applying
light pressure left toward the box until you
meet initial upward cut. Push Drywall Router
switch to off (Fig. 9).
Step 8: The completed box, executed quickly,
neatly, and in a fraction of the time taken by
other methods.
5
6
NOTE: These step-by-step instructions are
generalized to acquaint you with the Drywall
Router's operation. After some practice, you
may develop a technique with which you are
more comfortable. However, you must always
begin the cut somewhat centrally, and MOVE
THE DRYWALL ROUTER ONLY COUNTER-
CLOCKWISE to take advantage of the
"hugging" action of the bit along the contours
of the template. Remember to use a smooth,
continuous motion. The exception to this rule
applies to cutting window and door openings.
Since you are tracing around the inside of the
framing members, move the bit clockwise to
take advantage of the bits "hugging" action.
-9-
FIG. 9
4
3
7