Setup Within The Vehicle - Babyauto POLAR FIX 01 Manual De Uso

4. setuP WIthIn the vehIcLe

place the child seat in the rear of the vehicle, facing
away from the direction of travel (Group 0+) or facing
forward (Group 1).
the child seat must be as closely attached to the
vehicle's seat as possible. For vehicles with adjustable
headrests, a better installation can be achieved by
adjusting the height or removing the headrest (fig. 1)
(Group 1).
it is important to replace the headrest in its position
when an adult is travelling.
the child seat must not be transported in the vehicle
without being buckled in, even when the child is not
travelling in the child seat. it is very important to keep
this in mind, in order to avoid any damage that the child
seat could cause in the event of an accident. the child
seat must therefore remain installed at all times while
driving.
Ensure that the distance between the child seat,
installed in the rear of the vehicle, and the front seats
is the maximum possible. (fig. 2).
20
fig. 1
fig. 2
5. InstALLAtIOn In the vehIcLe / gROuP 0+
5.1 Installation with a 3-point belt
Only gROuP 0. from approx.
WARnIng
)
0 to 10 months (0-10 kg
1. Connect the seat to the group 0+ (P) base by
inserting it into the holes on the top of the child seat
base (fig. 1)
2. recline the seat fully. pull the seat recline lever
upwards (I). recline the seat while keeping hold of
the lever. release the lever when the seat is in the
desired position (fig. 2).
3. place the child seat in the rear of the vehicle, facing
away from the direction of travel (fig. 3)
4. unlock the safety catch (K) by turning it. remove it
to release the seat back (fig. 4)
5. Move the backrest forward and thread the vehicle's
seat belt between the seat's backrest and base
(fig. 5 /6)
6. thread the lap belt through the bottom harness
(L)
guides and fasten the vehicle's seat belt latch,
pressing until you hear a click. (fig.7)
fig. 1 fig. 2
fig. 3 fig. 4
fig. 5 fig. 6
21